The machining center is a highly automated multi-function CNC machine tool with a tool magazine and automatic tool changer, so regular maintenance is required to extend its cost.
Mechanical part:
1. Check the lubrication system, the status of the pressure gauge, clean the filter screen of the lubrication system, replace the lubricating oil, and clear the oil path,
2. Check the air circuit system, clean the air filter, and eliminate the leakage of pressure gas.
3. Check the fluid system, clean the filter, clean the oil tank, and replace or filter the oil. If possible, replace the seal.
4. Tighten the transmission components and replace the bad standard parts.
5. Lubricate grease parts, add grease as required
6. Clean and wash the transmission surfaces,
7. Check the status of the tool magazine and manipulator, analyze the wear state of the manipulator, and propose replacement suggestions to the customer.
8. Repair and correct damaged parts of external components.
9. Check the status of the protective cover. Accurately feed back information to customers.
Electrical part:
10. Clean the electrical components in the control cabinet, check and tighten the tightness of the terminal.
11. Clean and clean the control module, circuit board of CNC system, clean fan, air filter, clean heat dissipation device,
12. Clean the fan blades of the servo motor.
13. Clean the internal components of the operation panel, circuit boards and fans. Check the tightness of the connector.
If you want the machine to work steadily for a long time, you need to maintain and inspect it in a timely manner. The above points of attention hope to help the majority of users.
