Radial drilling machine is generally used in single piece mechanical products, small batch production workshop, product assembly workshop and mechanical repair workshop. The operating procedures of radial drilling machine are as follows:
1. Carefully check the drilling machine and work card quantity before work, and work only after confirmation.
2. It is strictly forbidden to wear gloves, and girls' braids should be put in their hats.
3. Workpiece clamping must be firm and reliable. When drilling small parts, it should be clamped with tools. It is not allowed to hold the drill by hand.
4. When using the automatic tool feed, it is necessary to select the feed speed and adjust the travel limit block. When manual feeding, it is generally carried out according to the principle of gradual pressurization and gradual decompression, so as to avoid accidents caused by excessive use.
5. When adjusting the speed, stroke, clamping tool and workpiece of the drilling machine, and when wiping the machine tool, stop the machine.
6. When there are long iron chips on the drill, stop the machine to remove them. It is forbidden to blow with wind or pull with hand. It should be removed with brush or hook.
7. When fine reaming deep hole, pull out the round tool and pin bar, and do not use too much force to avoid hitting the tool with hands.
8. It is not allowed to turn, clamp or measure the workpiece under the rotating tool. Hands are not allowed to touch the rotating tool.
9. When using the rocker drill, there shall be no obstacles within the slewing range of the cross arm. Before working, the cross arm must be clamped tightly.
10. It is not allowed to store objects on the cross arm and worktable, and the processed parts must be clamped tightly according to regulations, so as to prevent serious personal injury accidents and equipment accidents caused by workpiece displacement.
11. At the end of the work, lower the cross arm, keep the headstock close to the column, and clamp them tightly.
Radial drilling machine spindle feed box maintenance: check the oil quality, keep good, oil quantity meet the requirements. Remove the burr of spindle taper hole. Clean the hydraulic transmission system and oil filter net, and adjust the oil pressure.
